188 Reading: Growth and Recession in the AS–AD Diagram

Unemployment in the AS–AD Diagram

Two types of unemployment were described in the Unemployment chapter. Cyclical unemploymentbounces up and down according to the short-run movements of GDP. Over the long run, in the United States, the unemployment rate typically hovers around 5% (give or take one percentage point or so), when the economy is healthy. In many of the national economies across Europe, the rate of unemployment in recent decades has only dropped to about 10% or a bit lower, even in good economic years. This baseline level of unemployment that occurs year-in and year-out is called the natural rate of unemployment and is determined by how well the structures of market and government institutions in the economy lead to a matching of workers and employers in the labor market. Potential GDP can imply different unemployment rates in different economies, depending on the natural rate of unemployment for that economy. In the AS–AD diagram, cyclical unemployment is shown by how close the economy is to the potential or full employment level of GDP. Returning to Figure 10.9, relatively low cyclical unemployment for an economy occurs when the level of output is close to potential GDP, as in the equilibrium point E₁. Conversely, high cyclical unemployment arises when the output is substantially to the left of potential GDP on the AS–AD diagram, as at the equilibrium point E₀. The factors that determine the natural rate of unemployment are not shown separately in the AS–AD model, although they are implicitly part of what determines potential GDP or full employment GDP in a given economy.

Inflationary Pressures in the AS–AD Diagram

Inflation fluctuates in the short run. Higher inflation rates have typically occurred either during or just after economic booms: for example, the biggest spurts of inflation in the U.S. economy during the twentieth century followed the wartime booms of World War I and World War II. Conversely, rates of inflation decline during recessions. As an extreme example, inflation actually became negative—a situation called “deflation”—during the Great Depression. Even during the relatively short recession of 1991–1992, the rate of inflation declined from 5.4% in 1990 to 3.0% in 1992. During the relatively short recession of 2001, the rate of inflation declined from 3.4% in 2000 to 1.6% in 2002. During the deep recession of 2007–2009, the rate of inflation declined from 3.8% in 2008 to –0.4% in 2009. Some countries have experienced bouts of high inflation that lasted for years. In the U.S. economy since the mid–1980s, inflation does not seem to have had any long-term trend to be substantially higher or lower; instead, it has stayed in the range of 1–5% annually.

The AS–AD framework implies two ways that inflationary pressures may arise. One possible trigger is if aggregate demand continues to shift to the right when the economy is already at or near potential GDP and full employment, thus pushing the macroeconomic equilibrium into the steep portion of the AS curve. In Figure 10.10 (a), there is a shift of aggregate demand to the right; the new equilibrium E₁ is clearly at a higher price level than the original equilibrium E₀. In this situation, the aggregate demand in the economy has soared so high that firms in the economy are not capable of producing additional goods, because labor and physical capital are fully employed, and so additional increases in aggregate demand can only result in a rise in the price level.

An alternative source of inflationary pressures can occur due to a rise in input prices that affects many or most firms across the economy—perhaps an important input to production like oil or labor—and causes the aggregate supply curve to shift back to the left. In Figure 10.10 (b), the shift of the AS curve to the left also increases the price level from P₀ at the original equilibrium (E₀) to a higher price level of P₁ at the new equilibrium (E₁). In effect, the rise in input prices ends up, after the final output is produced and sold, being passed along in the form of a higher price level for outputs. The AS–AD diagram shows only a one-time shift in the price level. It does not address the question of what would cause inflation either to vanish after a year, or to sustain itself for several years. There are two explanations for why inflation may persist over time. One way that continual inflationary price increases can occur is if the government continually attempts to stimulate aggregate demand in a way that keeps pushing the AD curve when it is already in the steep portion of the AS curve. A second possibility is that, if inflation has been occurring for several years, a certain level of inflation may come to be expected. For example, if consumers, workers, and businesses all expect prices and wages to rise by a certain amount, then these expected rises in the price level can become built into the annual increases of prices, wages, and interest rates of the economy. These two reasons are interrelated, because if a government fosters a macroeconomic environment with inflationary pressures, then people will grow to expect inflation. However, the AS–AD diagram does not show these patterns of ongoing or expected inflation in a direct way.

Importance of the Aggregate Supply–Aggregate Demand Model

Macroeconomics takes an overall view of the economy, which means that it needs to juggle many different concepts. For example, start with the three macroeconomic goals of growth, low inflation, and low unemployment. Aggregate demand has four elements: consumption, investment, government spending, and exports less imports. Aggregate supply reveals how businesses throughout the economy will react to a higher price level for outputs. Finally, a wide array of economic events and policy decisions can affect aggregate demand and aggregate supply, including government tax and spending decisions; consumer and business confidence; changes in prices of key inputs like oil; and technology that brings higher levels of productivity. The aggregate supply–aggregate demand model is one of the fundamental diagrams in this text because it provides an overall framework for bringing these factors together in one diagram. Indeed, some version of the AS–AD model will appear in every module in the rest of this text.